fresh msgnks brushless flywheelers updated to v1.3, now using Trifolium firmware, which enables them to hit 200fps with less than 120ms delay.

I did this so I can finally be accepted by the pro competitive dartsofters, but they once again banned me from their discord for using an alt account and not keeping my thoughts in the venting channel, whatever that means ig ://

Having built Hammerhead, this was a breeze lol, just an awesome lil blaster to plink with

Made a collet for the Xshot longshot 2.0!

Works with the stock barrel/bcar as well

Files can be found here:

https://makerworld.com/en/models/3505956-xshot-longshot-2-0-barrel-collet#profileId-4005578

My pvp load out, 240 fps xsls, moded outlaw, chest rig, and a solo pro i carry, 3 15 dart mag, 3 12 dart mags and a 12 mag on the blaster, an outlaw with another cilinder on the pouch over the holster, and two 6 round angled talons if a decide to run my brute pro as a secondary and a litle solo pro (i play at an airsoft field and play with my friends who also play airsoft just like me i love both hobbys :))
I PLAY AT A PRIVATE FIELD WICH IS UNDER EVERY LEGAL REGULATION TO OPERATE, I DONT WEAR THIS ON PUBLIC AND YOU SHOULD NOT USE TAC GEAR IN PUBLIC

I was looking for some cool blasters and they have a good selection but the shipping is way too high to be viable for me. Are there any other sites to buy higher end blasters with cheaper shipping?

Hi, so I was just chilling on ebay, looking for rebelle stuff, because it's always been my favorite line.

and uh...what the fuck is this? I don't think I've ever seen it before, it's not on the nerf wiki.

someone has it in the original packaging (original listing)

and someone also has it outside of the packaging(original listing)

I am pretty well versed in rebelle, and even more well versed in the catalog of nerf bows. and I have no clue what this is.

can anyone else weigh in?

Since I want to get a 3d printer, I also want to experiment with lights in blasters, for sci Fi designs and so on, but I have to figure out how to accomplish that, I need a plastic that spreads the light from the inside of the blaster evenly, a homogeneous light that doesn't let you see the individual LEDs, so some sort of foggy transparent plastic, idk if it exists, or how it's called, or if it can be 3d printed

Im planning to mod my Rapidstrike to shoot full length darts at a decent rate of fire to run on a 3S lipo, here are the parts (all sourced from CC due to shipping costs)

3x Kraken 3S 130 motors for flywheels and pusher
CC Rapidstrike Overhaul pack with 42.5mm motor spacing
CC Cyclone Flywheels

Q1: Is the motor spacing sufficient for these flywheels and what is the minimum current input for Kraken motors so I can decide what Lipo battery to get.

Q2: Does the 3d printed CC switch plate make the trigger feel very shallow and reduces the travel distance of the trigger pull significantly? (since there is no spring and only the microswitch)

I’ve done several modifications to my Stampede and it looks great, but the reset spring is too weak. I currently use a 9kg spring (22.5mm x 120mm) and it’s just not cutting it and while I bought a 14kg spring online, I was just informed it was mislabeled and it’s just another 9kg spring… Where do y’all get your springs?